RIP Quiz (Online) - Networkwalks Academy

1. Which of the following is true regarding RIPv2?

It has a lower administrative distance than RIPv1

It converges faster than RIPv1

It is harder to configure than RIPv1

It has the same timers as RIPv1

2. Which Layer4 port is used by RIP for updates?

TCP port 250

TCP port 520

UDP port 520

UDP port 250

Three of the networks have approximately 50 hosts each and one network has 10 hosts. The multi-vendor Routers are connected by serial links that use separate subnetwork numbers. The NW network has leased one Class C address to be used for all networks and serial links and they do not wish to replace any of their existing Routers. Which Routing protocol would be most appropriate for this scenario?

TCP/IP

IGRP

RIP v2

RIP v1

All of the others

EIGRP

4. Which protocol gives a full route table update every 30 seconds?

IEGRP

Both IEGRPand RIP

None of the mentioned

RIP

Based on the information shown above, which routing protocols can be used within this NW network shown in the diagram? (Choose three)

RIP v1

IGRP

OSPF

BGP

RP v2

EIGRP

6. What is route poisoning in RIP?:

It is information received from a Router that can’t be sent back to the originating Router

It sends back the protocol received from a router as a poison pill, which stops the regular updates

It prevents regular update messages from reinstating a route that has just come up

It describes when a router sets the metric for a down link to infinity

7. How often does a RIPv1 router broadcast its routing table by default?

Every 30 seconds

Every 90 seconds

Every 60 seconds

RIPv1 does not broadcast periodically

8. What is the effect of this IP scheme on the network?

IP traffic between all the LANs will be prevented

IP traffic between subnet R1 and R2 will be prevented

Routing information will not be exchanged

The addressing scheme will allow all IP traffic between the LANs

9. Which statement is true regarding classless routing protocols?:

RIPv1 is a classless routing protocol

The use of discontinuous networks is not allowed

RIPv2 supports classless routing

The use of variable length subnet masks is permitted

10.
What is the Maximum Hop count for RIP?

255